Lubricant

『PIN CARE NEXT』　～Dry type, Lubricants～

To be dry type lubricant with thin film. It is the best lubricant for applies to the shaping part like the ejector pin, slide parts, etc. that you are worry about the stain. Also, it can be used under severe temperature conditions.
【Temperature ranging from：－２０℃～３００℃】

『K-3』　～Oil type, Lubricants～　　

To be oil type lubricant with contains PTFE. The heat resistant, pressure resistant is excellent, and lubricating takes durable effect. Especially, it is the most suitable for lubricant of injection mould with thermosetting.
【Temperature ranging from：－２０℃～２５０℃】

『SPRAY GREASE WHITE』　～Grease type, Lubricants～

To be white grease lubricant with odourless. It is the most suitable for grease spraying of the part　which unreachable. Since it is white grease, parts are also difficult to dirty. This spray can be used upside-down.
【Temperature ranging from：－２０℃～１５０℃】

『J-1』　～Dry type, Lubricants～

To be dry type lubricant with contains fluorine resin powder, it is suitable for applied to the moveable part that do not want to be dirty. To compare with Pin care, effectiveness is weaker than, but the stickiness and blot is very little.
【Temperature ranging from：－２０℃～２５０℃】

『MOULD HELPER』　～Dry type, Lubricants & Anti-rust～

To be dry type lubricant with contains fluorine resin. So, the stickiness and blot is very little. In additional, it contains anti-rust component, so able to applied to the moveable part without dirty. It has hardly effect on plastic.
【Temperature ranging from：－２０℃～２５０℃】

Latest Update 28 Jan 2019